Raspberry Pi OLD VERSION .Gehäuse aus Sperrholz

This is a case for Raspberry Pi computer,OLD VERSION. Raspberry Pi computer NOT INCLUDED

made on birch plywood of 3 mm thickness.

The package Includes: 6 pieces of birch plywood.

Not necessary to use tools or glue for assembly.

Notes on Assembly:

The plywood case clicks together, relying on the slight flexibility of the plywood in place of screws or other hardware.

DO NOT FORCE ANYTHING! If flexed too hard, plywood will break.

All the pieces should assemble with minimal finger pressure.

If a part is uncooperative, something is misaligned...back off and check your progress, do not press harder!

1º Position the first side of the case, with the Audio Out and Composite Video Out jacks.

2º Position the 2ª side of the case, with the USB and LAN port.

3º Position the 3ª side of the case, with the HDMI video port.

4º Position the 4ª Side of case, with Power, SD CARD ports.

5º Position the TOP Piece,slide the top of the end piece over the two top hooks, then, using very light pressure.

6º Position the Botton, Using the same technique as for the top.

If you have any questions please contact before buy.

"Raspberry Pi is a trademark of the Raspberry Pi Foundation"